Atmel AT91SAM7X-EK Manual Online: Errata. E–ATARM–Mar Motherboard Atmel AT91SAMEK User Manual. (39 pages). Motherboard. 7: Only available on products with embedded Flash. 8, 10, 16, 17, 19, 20, 21, On board DataFlash chip. 9: Please check at91sam errata # Example: To compile a DataFlash boot project for AT91SAMEK board, type the following commands: 3: Please check at91sam errata #

Author: Aram Vutilar
Country: Zimbabwe
Language: English (Spanish)
Genre: Environment
Published (Last): 4 July 2011
Pages: 124
PDF File Size: 20.33 Mb
ePub File Size: 19.56 Mb
ISBN: 987-6-61993-469-1
Downloads: 11551
Price: Free* [*Free Regsitration Required]
Uploader: Mezijora

All material on this collaboration at91sm9260 is the property of the contributing authors. Jumpers Configuration Designation Note: Supported on SAM rev B onwards In the linux4SAM pre-built demo it is used to configure the hardware and to load and start the standard U-Boot bootloader, it can also be configured to start directly the linux kernel.

Usually cross-compiler-prefix- looks like arm-linux- or arm-elf- Notes 1: Not available with the lead PQFP package. Dataflash erata have page size of bytes, 0x hex and the load address 0x is thus in the middle of a page. Added errata Section 6. For more information on this topic, please check the corresponding SAM product datasheet section Boot Program.

Internal RC Oscillator AT73C clocking In the present schematics block diagram p. Coaxial plug center positive standard. To use the software shutdown control, J3 must be opened. Removable DataFlash card 89: Reproduction and publication without our written authorization shall expose offender to legal proceedings. Power supply and audio! Atmel makes no representations or warranties with respect to the accuracy or completeness of the contents of this document and reserves the right to make changes to specifications and product descriptions at any time without notice.


Unless specifically provided otherwise, Atmel products are not suitable for, and shall not be used in, automotive applications. Added new schematics in Section 5. All EBI Signals of the AT91SAM are routed to extension footprint connectors J25 This allows the developer to check the integrity of the components and to extend the features of the board by adding external hardware components or boards. Refer to Section 4.

A grounding strap or similar protective device should be worn when handling the board. The board must not be subjected to high electrostatic potentials.

Please check at91sam errata If S3 is closed, R13 must be unsoldered. On J10 pin 3: Choose the proper media tab DataFlash, NandFlash, etc. Only one available with the lead PQFP package.

AT91SAM – Microprocessors – Microcontrollers and Processors

On J10 pin 1 square pin: The information in this document is provided in connection with Atmel products. The markings for BB and 1V8 are inverted. Board Layout – Top View!


The marking should be: You can find edrata valuable summary in the document named SAM9 Boot Strategies or see the cross matrix below. Supported on SAM rev B onwards 7: A GND Test point.

Ineltek » EOLs and PCNs

Added new Section 6, Errata. Only available on products with embedded Flash 241011131415 Avoid touching the component pins or any rrrata metallic element.

Other terms and product names may be trademarks of others. To use this feature, the user has to open the strap and insert an anmeter.

Two user input pushbuttons 2! Atmel does not make any commitment to update the information contained herein.

At91sam9260 rtos reference manual =937=

In this case, J10 configuration must be set in position 1, 2. Printed on recycled paper. One user green LED!