Circuit that is used in DENON’s high-end integrated amplifiers and has been criti- The PMAAE employs DENON’s Signal Level Divided Construction. A broad-branded circuit technique and a single-stage output circuit on high- current transistors are used in PMAAE. The equalizer, loudness scheme ( both. Denon PMAAESilver Amplifier. Great Integrated Amplifier.

Author: Brak Daizshura
Country: Martinique
Language: English (Spanish)
Genre: Sex
Published (Last): 17 December 2007
Pages: 116
PDF File Size: 10.90 Mb
ePub File Size: 11.10 Mb
ISBN: 977-5-74051-403-9
Downloads: 5059
Price: Free* [*Free Regsitration Required]
Uploader: Dakasa

Damping factor was very good: Since I was interested to re-check the balance and frequency response tests on a fresh sample, I borrowed a brand-new PMAAE and had Newport Test Labs rerun the balance and frequency response tests on this second sample.

Stability into an extremely capacitative denin was excellent. Square wave performance was excellent, with the Hz square wave showing negligible tilt and almost no curvature across the flats.

At 1kHz, the Denon delivered a little more again watts, or With a 4O load, the second harmonic component crept up to —90dB 0. Phase error at 20kHz was a little on the high side, but nothing to be concerned about. This time around the results were near-perfect, with channel balance improving to dneon.


And for the price, excellent hi-fi performance. This is exceptional performance, by any standard. However, all the low-order harmonics were at or below —80dB 0. You can download a pdf of the denno magazine pages on which this review was published, which includes all the graphs, test result charts, tabulated results and oscillograms mentioned in the test results, by clicking HERE or on the graphic at right.

Denon PMAAE Silver Great Integrated Amplifier – Buy from Sound and Vision

Distortion increased at rated output, as would be expected, with the lower-order harmonics increasing in level, and additional, higher-order components appearing above the noise floor. Even the two sidebands were an excellent —95dB. You can clearly see the power supply limitation at 20Hz however, where the Pmw-700ae returned watts Distortion was very low, as you can tell from the spectrograms. The 1kHz wave was nearly perfect, and the 10kHz wave showed a very fast rise-time with very little rounding.


The overall THD figures are tabulated in the chart, at 0.

The Denon was no slouch into 4O loads either, producing watts David Ella and tested by Steve Holding Magazine: Channel separation was good, with a best of 79dB at 20Hz, reducing to 72dB at 1kHz and 48dB at 20kHz, however the balance between the left and right channels was very slightly out, with a 1.

Of some significance was the CCIF intermodulation test, which showed two sidebands at 18kHz and 21kHz surrounding the 19kHz and 20kHz test signals but only the tiniest re-generated signal at 1kHz, at —dB.

As you can see, what little ringing there was was quickly damped. With the tone controls engaged, the low-frequency response slopes down from 1kHz to end up 2dB down at 80Hz and a further 0. This is not a large error: